|
|
|
Is Your Remote Dead?
These instructions will reset your remote's microprocessor.
Many times that's all you need to restart your remote.
Step 1-
Pull the batteries out of the remote and leave them out until Step
4.
Step 2-
Press and release each and every button one at a time on the
remote control until every button has been pressed and released
at least once!
Step 3-
If your remote has slide switches, you must move the switch to
each position then repeat the button pushing in Step 2.
(When you're done, be sure to put the slide switch in the correct
position to operate the unit the remote came with!)
Step 4-
Put the batteries back into the remote, being very careful to
install them correctly.
New batteries should be used if you're not sure about the old
ones.
Step 5-
Try the remote.
If your remote now works, Great!
If not, it's time to call 1-800-Remotes or go to
Remotes.com.
Special Note:
If you have a digital camera, camcorder or camera phone you can
test the remote to see if it is emitting a signal. Face the
remote towards the lens of the digital unit until you can see
the front of the remote. Depress any button on the remote. You
should see a light (steady, blink or flashing) being emitted
from the remote. If you do then the problem might not be the
remote but the sensor on the unit.
If you are NOT Satisfied with your Universal Remote, Go To
Remotes.com to see if an
Original Replacement Remote is available.
|
|
